15222 Autoloader ALE: remove plate from load ramp (wrong size) Platesetter_3244 After winding the plate almost all the way onto the drum, but leaving the lower load ramp sensor covered, the load ramp sensor is checked. If no plate is sensed then the plate is presumably too small. It will then unwind the plate and release the LEC and roller for the operator to remove the plate. Lift brige and open front panel, remove plate from load ramp, select resume or cancel. Check plate main scan size that is loaded into the bay. Plate was slightly smaller than expected. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:58 2008 PST